Anderson Plug Shenghong Electronics discusses the development trend. Nowadays, for connector companies, in order to gain a foothold in the connector industry, they must accelerate the pace of industrial adjustment, increase technological innovation and capital investment, in order to produce high-performance connectors that meet market demand and keep up with the development of the times. Overall, the development characteristics of the connector field are: high-speed, digital, and integrated signal transmission; Small size, narrow spacing, and multifunctionality of product volume; Convenient insertion and module combination; Low cost of products. In addition, it is also required to develop assembly technology towards surface mount technology (SMT) and microassembly (MPT). There are still many new industries that have a demand for connectors, many of which have high requirements for connector technology. Faced with the market and technological changes in connectors, China should constantly track the forefront of connector technology, learn new connector technologies, gradually get rid of competition from mid to low end product types, and develop high-end product lines.

  The Anderson plug is configured to uniquely identify the position. Misinsertion is an error caused by careless operation by the staff. This behavior not only prevents the equipment from functioning properly, but in severe cases, it may also cause a short circuit in the circuit. Therefore, the requirements for preventing misconnection are very high. According to Mr. Yuan from Baihui Connector, there are two aspects to preventing accidental insertion of wire to wire connectors, as follows: on the one hand, for the wire to wire connector itself, rotating 180 degrees can cause signal connection errors if there is a misalignment error. At this time, it is necessary to pay attention to choosing wire to wire connectors that prevent accidental insertion as much as possible. This can avoid such errors and also prevent equipment damage. Using wire to wire connectors can to some extent avoid the occurrence of such situations in power connectors. Therefore, it is recommended that in order to reduce material types or save costs, manufacturers must choose reliable and safe wire to wire connector products during use, which can provide good protection for their equipment. It can also be configured uniquely by adjusting the relative position in the wire to wire connector.